Airo ORIA Serie Manual De Usuario página 39

Prior to the task being carried out, an oil and refrigerant sample shall be taken in case analysis is required prior
to re-use of reclaimed refrigerant. lt is essential that electrical power is available before the task is commenced.
a) Become familiar with the equipment and its operation.
b) lsolate system electrically.
e) Before attempting the procedure ensure that:
• Mechanical handling equipment is available, if required, for handling refrigerant cylinders;
• AII personal protective equipment is available and being used correctly;
• The recovery process is supervisad al all times by a competen! person;
• Recovery equipment and cylinders conform to the appropriate standards.
d) Pump down refrigerant system, if possible.
e) lf a vacuum is not possible, make a manifold so that refrigerant can be removed from various parts of the
system.
f) Make sure that cylinder is situated on the scales before recovery takes place.
g) Start the recovery machina and operate in accordance with manufacturer's instructions.
h) Do not overfill cylinders. (No more than 80 % volume liquid charge).
i) Do not exceed the maximum working pressure of the cylinder, even temporarily.
j) When the cylinders have been filled correctly and the process completad, make sure that the cylinders and
the equipment are removed from site promptly and all isolation valvas on the equipment are closed off.
k) Recovered refrigeran! shall not be charged into another refrigeration system unless it has
been cleaned and checked.
Labelling
15.
Equipment shall be labelled stating that it has been de-commissioned and emptied of refrigerant.
The label shall be dated and signad.
Ensure that there are labels on the equipment stating the equipment contains flammable refrigerant.
Recovery
16.
• When removing refrigerant from a system, either for servicing or decommissioning, it is recommended good
practica that all refrigerants are removed safely.
• When transferring refrigerant into cylinders, ensure that only appropriate refrigerant recovery cylinders are
employed.
• Ensure that the correct number of cylinders for holding the total system charge is available.
• AII cylinders to be used are designated for the recovered refrigeran! and labelled for that refrigeran! (i.e.
special cylinders for the recovery of refrigeran!).
• Cylinders shall be complete with pressure relief valve and associated shut-off valvas in good working order.
• Empty recovery cylinders are evacuated and, if possible, cooled before recovery occurs.
• The recovery equipment shall be in good working order with a set of instructions concerning the equipment
that is al hand and shall be suitable for the recovery of flammable refrigerants.
• In addition, a set of calibrated weighing scales shall be available and in good working order.
• Hoses shall be complete with leak-free disconnect couplings and in good condition.
• Before using the recovery machina, check that it is in satisfactory working order, has been properly
maintained and that any associated electrical components are sealed to prevent ignition in the event of a
refrigerant ralease.
• Consult manufacturar if in doubt.
• The recovered refrigeran! shall be returned to the refrigeran! supplier in the corree! recovery cylinder, and
the relevan! Waste Transfer Note arranged.
• Do not mix refrigerants in recovery units and especially not in cylinders.
• lf compressors or compressor oils are to be removed, ensure that they have been evacuated to an
acceptable level to make certain that flammable refrigerant does not remain within the lubricant.
• The evacuation process shall be carried out prior to returning the compressor to the suppliers.
• Only electric heating to the compressor body shall be employed to accelerate this process.
• When oil is drained from a system, it shall be carried out safely.
�WARNING
38
Safety Precautions