Cleaning And Maintenance; Safety Information; Cleaning And Descaling; Cleaning And Descaling Function - Caso HW 660 Manual Del Usuario

Press and hold
"000" is shown press Start/Stop for confirmation. The device perfoms the calibration and
beeps once process is finished.

15 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining the
device. Please observe the notices to prevent damages due to cleaning the device incorrectly
and to ensure trouble-free operation.

15.1 Safety information

Please observe the safety instructions, before cleaning your device
► Unplug the device when not in use and before any cleaning.
► Never immerse the unit, cord or plug in water or other liquids and do not place in the
dishwasher.
► Do not use iron brush, abradant, kitchen cleaner, or sharp cleaning tool for cleaning.

15.2 Cleaning and descaling

Wipe the device with damp cloth.
Drainage stopper
After cleaning of the device, please take out the drainage stopper
(3) in order to clean up waste water. Put the drainage stopper back
in after opening it. Make sure it is fastened properly.
► If you need to send the device to customer service, then first
remove the water from the device.
15.2.1

Cleaning and descaling function

When "Descale" is blinking in the display then the device needs to be descaled, please
proceed as follows:
Place device without drip tray and without water filter. Fill the watertank up to max marking.
Add a little bit of vinegar.
Place vessel below the spout which can collect whole content of watertank.
Temp-button for 3 seconds until „CAL" is displayed. When volume
Attention
Please note
36