Malfunctions - SATA jet 1000 A RP/HVLP Instrucciones De Servicio

Operating Instructions SATA Automatic Gun
EN
Attention!
The use of aggressive cleaning
agents can damage the automat-
ic gun.
→ Do not use aggressive cleaning
agents.
Only use suitable cleaning solu-
tions for cleaning.
→ Use a neutral cleaning solution
with a pH of 6–8.
→ Do not use acids, caustic
solutions, bases, paint strippers,
unsuitable regenerates or other
aggressive cleaning agents.
There is a risk of corrosion if the
automatic gun is submerged in
the cleaning solution. → Do not
submerge the automatic gun in
cleaning solution.
Incorrect cleaning tools can
damage the holes and impair the
spray fan pattern.
→ Only use the SATA cleaning
brushes.
→ Never use ultrasonic cleaners.

12. Malfunctions

The following table describes mal-
functions together with their causes
and corrective action.
If it is not possible to remedy a
malfunction with the described cor-
rective action, send the automatic
gun to the SATA customer service
department. (Address see chapter
110
13).
Malfunc- Cause
tion
Fluttering Fluid tip not
spray fan properly
pattern tightened.
Air distri-
bution ring
soiled or
damaged.
Loose air
cap.
Gap be-
tween air
cap and
fluid tip is
clogged.
Nozzle set
is soiled.
Damaged
nozzle set.
Material
flow pres-
sure not
constant.
Spritzbild Air cap hole
zu klein, clogged
schräg, ein- with paint.
seitig oder
spaltet.
Damaged
fluid tip
(fluid tip
aperture).
Correc-
tive ac-
Tighten fluid
tip.
Replace air
distribution
ring (see
chapter
10.2).
Tighten air
cap ring by
hand.
Clean gap.
Clean noz-
zle set.
Replace
nozzle set
(see chap-
ter 10.1)
Check ma-
terial flow
pressure.
Clean air
cap (see
chapter
10.1).
Check fluid
tip for signs
of damage.
Replace
nozzle set if
necessary
(see chap-
ter 10.1).