Routine Maintenance; Air Filter - Southland SEA438.1 Manual De Operación

Routine Maintenance

• Save all instructions
WARNING
Disconnect the spark plug before performing maintenance.
A

Air Filter:

Accumulated debris and dust in the Air Filter will reduce engine performance, increase fuel consumption and increases the
risk of engine damage. Clean the air filter every 5 hours of operation or more frequently in dusty applications.
1. Before removing Air Filter Cover, brush away any loose
dirt or debris on and around the filter cover.
2. To remove Air Filter Cover, unscrew the retaining knob
and carefully pull the cover out (see Figure 6).
3. Remove and clean foam filter.
• Light surface dust can readily be removed by
tapping the filter.
• Heavy deposits should be washed out in soap and
water. Squeeze out any remaining water and allow
the filter to completely dry.
WARNING
Never clean filter in gasoline or other flammable solvents.
B
Spark Plug:
Inspect the Spark Plug after every 10-15 hours of use; adjust Spark Plug gap and replace Spark Plug as necessary.
Replace Spark Plug every year to maintain engine performance and easy starting.
To inspect or replace the Spark Plug:
1. Remove the insulated Spark Plug boot.
2. Using appropriate tools, remove the spark plug by
turning counter-clockwise.
3. Clean and adjust the Spark Plug gap to 0.024 – 0.028
in. (0.6 - 0.7mm).
4. Replace any worn Spark Plug with a recommended
replacement (see PRODUCT SPECIFICATIONS).
Questions? Call Toll Free at 1-800-737-2112
4. Add a teaspoon of thin oil to the filter squeeze out any
excess oil.
5. Ensure that the On/Off Switch wire terminals are secure
and reinstall the Air Filter Cover.
5. Apply anti-seize compound to the Spark Plug threads
only following the manufacturer's instructions.
6. Install the Spark Plug finger tight in the cylinder head,
then tighten. Do not over tighten to 10 to 12 ft-lbs.
7. Replace the insulated Spark Plug boot.
EN - 9
Copyright © 2015 MAT Engine Technologies, LLC
Fig. 6