Blade Guard - RedMax SGCZ2401S Manual De Instrucciones

SE4
SE5
SE6
20
English
6. Set up
■ CUTTERCASE (SE4)
WARNING
The blade has very sharp edges. Be sure to use
protective gloves whenever handling it.
1. Remove the fastening screw(long) and the lock
screw(short) from the cuttercase.
2. While aligning the locking holes, install the
cuttercase assembly to the shaft casing.
3. Align the locking holes and screw in the lock screw
to the bottom by hand, then secure it with the
wrench provided. Do not tighten up the lock screw
with the holes out of alignment, or the cuttercase can
be damaged.
(1) Cuttercase
(2) Locking holes
NOTE
If the locking screw is tightened up with the holes out of
alignment, the cuttercase may be damaged.
4. Fasten the cuttercase fastening screw.

■ BLADE GUARD

Install the blade guard onto the shaft casing approx.
3cm away from the cuttercase. Fasten the clamp
uniformly. (SE5, SE6)