Safety Definitions - Southland SFTT142 Manual De Operación

Safety Definitions

• Save these instructions
Safety Alert Symbols
The following symbols are used on the product and in this manual to alert the operator of potential safety hazards.
Read them carefully, and understand their meaning.
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
DANGER
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
WARNING
Indicates a potentially hazardous situation which, if not avoided, may result in
CAUTION
minor/moderate injury.
Indicates a practice not related to personal injury which, if not avoided, may result in property damage.
NOTICE
The following symbols may be found on your tiller. Carefully read and understand their meaning.
Safety Warning Symbols
Indicates WARNING, DANGER, or
CAUTION.
Read operator's manual before operating
this machine. Failure to follow directions
could result in serious injury.
Do not use if children or bystanders are
present.
Rotating parts can cause serious injury.
Keep hands, feet and clothing away.
Wear eye protection complying with ANSI
Z87.1 and hearing protection.
Control and Operating Symbols
Oil Fill Location
Do Not Overfill. Add engine oil and
check quantity at this location
Clutch Lever
CLUTCH
ENGAGE
CONTROL Lifting the lever engages the tines.
DISENGAGE
Do not use gasoline containing more
than 10% ethanol.
Questions? Call Toll Free at 1-800-737-2112
Disconnect spark plug wire when not in use
or before servicing, cleaning, or performing
maintenance on the unit.
Engine exhaust contains carbon monoxide,
an odorless and deadly gas. NEVER run unit
indoors or in a poorly ventilated area.
Do NOT touch hot muffler or cylinder. These
parts are extremely hot from operation and
may remain hot for a short time after opera-
tion.
To reduce risk of fire, clean spilled gas and
oil and keep unit free from debris. Gasoline is
extremely flammable. Allow machine to cool
before refueling
ENG - 2
Copyright © 2016 MAT Engine Technologies, LLC
Push primer 3 times before starting
a cold engine. Important: For
starting a hot engine, push only
once.
Ignition Switch
Move switch position to start/stop
engine.
Place free hand on handle bar
before pulling recoil starter handle
with other hand.