Error Messages - Metrohm 756 KF Instrucciones Para El Uso

4.1.4 Error messages

E20
E21
E22
E23
E24
E25
E26
E28
E29
E30
E31
E32
E33
E36
E37
E38
E39
756/831 KF Coulometer, Instructions of Use
Error messages are added to the status messages and separated from them by the
sign ";".
Check exchange unit.
Exit: Mount Exchange Unit (properly) or &m $S.
Check electrode, short circuit.
Exit: Rectify fault or &m $S.
Check electrode, break.
Exit: Rectify fault or &m $S.
Division by zero.
Exit: The error message disappears on next start or on recalculation.
Check drive unit.
Exit: Connect drive unit (correctly) or &m $S.
Change reagent.
Exit: Error message disappears on next start or clear reagent counters
&Config.Monitoring.Reagent.ClearCount $G.
Manual stop.
Exit: The error message disappears on next start.
Wrong object call up
Exit: Send correct path for object. Start path at root.
Wrong value or no value allowed.
Exit: Send correct value or call up new object.
Wrong trigger, this trigger is not allowed or carrying-out of action not possible.
Exit: Send correct trigger (exception: $D) or call up new object.
Command is not possible in active status. Repeat command in inactive status.
Exit: Send new command.
Command is not possible during titration. Repeat command during the conditioning
phase or in inactive status.
Exit: Send new command.
Value has been corrected automatically.
Exit: Send new command.
RS receive errors:
Parity
Exit: <QUIT> and ensure settings of appropriate parameters at both de-
vices are the same.
Framing error
Exit: <QUIT> and ensure settings of appropriate parameters at both
devices are the same.
Overrun error. At least 1 character could not be read.
Exit: <QUIT>
The internal working-off buffer of the KF Coulometer is full (>82
characters).
Exit: <QUIT>
4.1 General rules
57