Installation; Before The Installation; Nstallation; Installation Of Built-In Ovens - EAS ELECTRIC EMV48DTN Manual De Instrucciones

4）Pull the door towards you ,pulling it out of its seat ;
Reassemble the door by following the above procedures backwards.
Replacing the oven Lamp
1) Disconnect the oven from the power supply by means of the Omni polar switch used to connect the
appliance to the electrical mains ;or unplug the appliance if the plug is accessible ;
2）Remove the glass cover of the lamp-holder ;
3）Remove the lamp and replace with a lamp resistant to high temperatures (300℃)
With the following characteristic.
 Voltage：220-240V
 Wattage：25W
 Type：E14
5）Replace the glass cover and reconnect the oven to the mains
Power supply
10、INSTALLATION

10.1 Before the Installation

 Please check the products shell and make sure that there is no trace caused by striking or heavy load.
 The oven door is level, and you can close door flexibly.
 Parameter on the nameplate is in compliance with the relevant regulations
When the oven working in a abnormal way, it must be stopped and unplug the power supply until it has
been repaired by a competent person from local agency or factory authorized service.
It is hazardous for anyone other than a competent person to carry out any service or repair operation

10.2 Installation

Only a qualified person in compliance with the instructions provided must install the
appliance .manufacturer declines all responsibility for improper installation, which may harm persons and
animals and damage property.
Important: - The power supply to the appliance must be cut off before any adjustments or maintenance
work is done on it;
- Air duct is supposed to use in Ventilation.
- The ac power supply should be 220-240 v, 50/60 Hz, the minimum 16 A distribution circuit
fuse, or at least 16 a distribution circuit breaker

10.3 Installation of Built-in Ovens

If we put the oven into cabinet, the material cabinet should be insulated, and the clearance between
the edge of the cabinet and the oven should be over 500mm for ventilation.
10 V.1