Premium PAC9039G Manual De Usuario página 34

Operation of wireless remote control
★
Blow over heat
When the unit is running in Heat mode or Auto Heat mode, compressor and indoor fan is
running, to turn the unit off, the compressor, outdoor fan will stop running. The upper and
lower guide board rotate to horizontal position, then the indoor fan will run at low fan speed,
10s later, the unit will turn off.
1.
Slightly to press the place
remote control.(As shown in figure)
2.
Take out the old batteries. (As show in figure)
3.
Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
(As show in figure)
4.
Attach the back cover of wireless remote control. (As show in figure)
★ NOTE:
●
When changing the batteries, do not use the old or different batteries,
otherwise, it can cause the malfunction of the wireless remote control.
●
If the wireless remote control will not be used for a long time, please
take them out, and don't let the leakage liquid damage the wireless
remote control.
●
The operation should be in its receiving range.
●
It should be placed at where is 1m away from the TV set or stereo sound sets.
●
If the wireless remote control can not operate normally, please take them out,
after 30s later and reinsert, if they cannot normally run, please change them.
If the wireless remote control is lostor broken,
please use the manual switch button. At this time,
the unit will run at the Auto mode, but the temperature
and fan speed cannot be changed. The operation
was shown as below:
To open the panel, the manual switch is on the
displayer box.
Turn on the unit: At unit turned off, press the button,
●
the unit will run at Auto mode immediately.The
microcomputer will accord to the indoor temperature
to select (Cooling, Heating, Fan) and obtain the
comfortable effect.
Turn off the unit: At unit turned on, press the button,
●
the unit will stop working.
Changing batteries and notices
to take out the back cover of wireless
Emergency operation
９
Fig.1
Fig.2
Manual switch
Fig.3