Bit Installation - Greenlee LRH-144 Manual De Instrucciones

Operation—Power Tool (cont'd)
• Do not use the power tool if the switch does
not turn it on and off. Any power tool that cannot
be controlled with the switch is dangerous and
must be repaired.
• Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such pre-
ventive safety measures reduce the risk of start-
ing the power tool accidentally.
• When storing or carrying the tool, set the Forward/
Reverse switch to the center position (switch
lock). Accidentally starting the tool may result in
injury.
• Do not strain the tool by holding the speed control
trigger halfway (speed control mode) so that the
motor stops. The protection circuit will activate
and may prevent speed control operation. If this
happens, release the speed control trigger and
squeeze again for normal operation.
• Be careful not to get dust inside the chuck.
• Do not drop the tool.
Failure to observe these precautions may result in
injury or property damage.

Bit Installation

Pinch points:
• Due to possibility of accidental
operation, remove battery when
changing bits.
• Keep hands away from spinning
parts while tool is in operation.
Failure to observe these warnings
could result in injury.
Use of a concrete drill bit larger than the recom-
mended size may cause damage to the tool.
Attaching the Bit
1. Insert the bit into the mounting hole, and turn it
slightly to locate an engaged position.
2. At the engaged position, push the bit as far as it
goes. Make sure that the bit is fixed by pulling it.
SDS PLUS
type shank
Removing the Bit
Depress the chuck and pull the bit.
Bit Adapter
Use a bit adapter and bit.
1. Remove the bit adapter from the bit adapter
holder on the main unit.
2. Pull the bit holder (1).
3. Insert the bit (2). Make sure the bit is inserted
firmly by pulling it lightly.
4. Insert the bit adapter into the mounting hole and
turn to locate an engaged position.
5. At the engaged position, push the bit in as far as
it goes. Make sure it does not move by pulling it
lightly.
10
Bit
holder