FALMEC Exploit Manual De Instrucciones página 18

SAFETY INSTRUCTIONS AND WARNINGS
INSTALLATION WARNINGS
TECHNICAL SAFETY
Installation operations are to be carried out by skilled and qualified installers in accordance with
the instructions in this booklet and in compliance with the regulations in force.
• Before installing the hood, check the integrity and function of each part. Should anomalies be noted,
do not proceed with installation and contact the Dealer.
• Do NOT install the hood if an aesthetic defect has been detected. Put it back into its original package
and contact the dealer. No claim can be made for aesthetic defects once the hood has been installed.
• During installation, always use personal protective equipment (e.g. accident-prevention shoes) and adopt
prudent and proper conduct.
• The fixing kit (screws and plugs) supplied with the hood can only be used on masonry walls: should it
be necessary to install the hood onto walls in a different material, assess other fixing systems keeping the wall
resistance and weight of the hood in mind (indicated on page 2 ).
• Keep in mind that installations with different types of fixing systems from those supplied, or which are not
compliant, can cause electrical and mechanical seal danger.
• Do not modify the electrical, mechanical and functional structure of the equipment.
• Do the install the hood outdoors and do not expose it to atmospheric agents (rain, wind, etc.)
ELECTRICAL SAFETY
The electrical system to which the hood is to be connected must be according to standard and
compulsorily supplied with earthed connection in compliance with safety regulations in the
country of use. It must also comply with European standards regarding radio antistatic proper-
ties.
• Before installing the hood, check that the electrical mains power supply corresponds with what is reported
on the identification plate located inside the hood.
• The socket used to connect the installed equipment to the electrical power supply must be within reach:
if this is not possible, install a mains switch in an accessible position in order to disconnect the hood when
required.
• Any changes to the electrical system required to install the hood must be carried out by a qualified electri-
cian.
• The maximum length of the flue fixing screws (supplied by the manufacturer) must be 13 mm. Use of non-
compliant screws with these instructions can lead to danger of an electrical nature.
• It is dangerous to change, or try to change, the features of this equipment. Do not try to solve the problem
yourself in the event of equipment malfunction, but contact the Dealer or an authorised Servicing Depart-
ment for repairs.
• When installing the hood, disconnect the equipment by removing the plug or switching off the main
switch.
FUMES DISCHARGE SAFETY
• Do not connect the equipment to discharge pipes of fumes produced from combustion (for example
boilers, fireplaces, etc.)
• Before installing the hood, ensure that all standards in force regarding discharge of air out of the room have
been complied with.
USER WARNINGS
GENERAL WARNINGS
These warnings have been drawn up for your personal safety and those of others. You are there-
fore kindly asked to read the booklet carefully in its entirety before installing and using the equip-
18