Technical Data; Moving And Storage - Tunturi J 660 Manual Del Usuario

2. Insure the tether key is properly inserted.
3. Insure the power cord is properly plugged.
4. Insure the treadmill is properly lubricated (see 4.3.
LUBRICATING THE RUNNING DECK).
5. If the error code does not disappear after the
above mentioned maintenance actions, please
contact your local TUNTURI dealer. Always give
the error code and serial number (see the sticker
at the back of the frame, below the left-hand side
rail).
tEtH The tether key is not properly installed
In spite of continuous quality control, individual defects and
malfunctions may occur due to individual components. It is
in most cases unnecessary to take the whole treadmill for
repair, as it is usually sufficient to replace the defective part.
4.5. USER MAINTENANCE MENU
The total treadmill running time and total distance are
automatically saved in the memory of the treadmill. If you
wish to check the total values during assembly measures, for
example, proceed as follows:
1. Press and hold the STOP key while pressing the
SCAN/SELECT key (when meter displays "enter
weight" mode). The meter displays the user set
up mode.
2. Press and hold the STOP key again while
pressing first the SCAN/SELECT key and then
the ENTER key.
3. The meter will scan the following functions:
software version, total time and total distance.
4. Press ENTER key twice to exit the user
maintenance menu.

5. MOVING AND STORAGE

The J 660 is equipped with wheels for easy mobility. Before
moving, be sure the power cord is unplugged from the wall
and the treadmill. Lift the rear end of the treadmill, then push
or pull, rolling the treadmill on the front wheels.
NOTE! The running belt may need to be realigned and
centered after moving (see 3.1. ALIGNING THE RUNNING
BELT and 3.2. ADJUSTING THE BELT TENSION).
To prevent malfunctioning of the treadmill, store it in a dry
place with as little temperature variation as possible,
protected against dust. Always unplug the treadmill from the
electrical outlet when not in use.
NOTE! If the treadmill is not used for at least three
weeks, it must be carefully lubricated per the lubrication
instructions!
GB

6. TECHNICAL DATA

Length
Height
Width
Weight
Running surface length
Running surface width
Speed
Elevation range
Meter
Motor
Drive system
Structural frame
Maximum user weight
All TUNTURI models are designed to meet the electro-
magnetic compatibility directive, EMC and are affixed with
the CE conformity marking.
All TUNTURI treadmills meet DIN accuracy and safety
norms (DIN 32933-1+3).
Due to our continuous programme of product develop-
ment we reserve the right to change specifications
without notice.
11
150 cm / 60"
125 cm / 49,2"
90 cm / 36"
71 kg / 156 lbs
135 cm / 54"
44 cm / 17,6"
1.5 -16 km/h / 1-10 mph
0 - 10 %
Distance
Elevation
Pulse (optional)
Time
Pace
Speed
Energy consumption
LED display
5 preprogrammed workouts,
1 user programme
1,5 HP
Drive belt
Welded steel, powder coated
110 kg