Triton JOF 001 Instrucciones De Uso página 6

SYMBOLS
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.
Always wear ear, eye and respiratory
protection.
Conforms to relevant legislation
and safety standards.
FUNCTIONS
Power switch
• When the router is connected to power, the Switch (3)
will illuminate (in both 'on' and 'off' positions).
• The retracting switch cover prevents accidental starting
of the router. It must be retracted before the router can
be switched on. The cover will remain open until the
router is switched off
Adjusting the depth of cut
There are two ways to adjust the cutting depth:
• Free Plunge, for conventional & fast depth adjustment
• Micro Adjuster, for precise depth setting throughout the
full plunge range
Free Plunge
1. Disengage the Plunge Lock Lever (7)
2. Using the handles, push the router down to the required
plunge depth
3. Engage the plunge lock lever to lock the router at the
required depth
GB
Micro Adjuster
1. Disengage the Plunge Lock
Lever (7)
2. Turn the Micro Winder (8)
until the router bit is at the
depth required. Turn clock-
Symbols / Functions
6
WARNING. To reduce the
risk of injury, user must read instruction
manual
Instruction warning.
Double insulated for additional
protection
wise to increase cut depth,
anticlockwise to reduce cut
depth
3. Engage the plunge lock lever
when the router is at the
required depth, particularly
for heavy cuts
Fitting a collet and router bit
1. Ensure the power switch is OFF and the router discon-
nected from mains (the retracting shutter will lock
closed)
2. Check the depth stop is fully retracted (see 'Depth Stop
and Turret') and release the Plunge Lock Lever (7)
3. Turn the machine upside down
4. Plunge the router to its
maximum depth and engage
the plunge lock lever to lock
the router in this position
NOTE: On first use, when you
take the router out of the box,
the router is in this position
5. Rotate the threaded spindle as
necessary to engage the spindle lock
Fitting a collet
1. Place collet onto the spindle so that it engages the
screw threads
2. Turn the collet clockwise by hand so that it is fully
mounted onto the spindle