Connecting The Dmx Bus; Connecting The Power Supply; Start-Up; Addressing Via Dmx - Oase DMX 02 Instrucciones De Uso

- GB -
4.4

Connecting the DMX bus

1. How to proceed:
0.
B, D, E
11. Remove the protection cap from the DMX-Box.
− DMX-IN: Connection for DMX input signal (WECS)
− DMX-OUT: Connection for DMX signal to further units (signal feedthrough). A terminator has to be plug-
ged into DMX-OUT (termination of the DMX bus) of the last unit.
12. Fit the connector of the connection cable and secure with the two screws (max. 2.0 Nm).
− Ensure that the rubber seal is clean and fits exactly.
− Replace the rubber seal if damaged.
4.5

Connecting the power supply

1. How to proceed:
0.
B, D, E
13. Remove the protection cap from PowerBox 24 V DC.
− The two 24 V DC sockets are connected in parallel. The second 24 V DC socket can be used for supply-
ing other units (signal feed-through).
14. Fit the connector of the connection cable and secure with the two screws (max. 2.0 Nm).
− Ensure that the rubber seal is clean and fits exactly.
− Replace the rubber seal if damaged.
5

Start-up

This unit supports the DMX protocol extension RDM.
• Start-up and operation are possible with a DMX controller or DMX/RDM controller.
• The DMX / RDM protocol is used for signal transmission and control.
5.1

Addressing via DMX

DMX (Digital Multiplex) is a standardised digital transmission protocol used in stage and event equipment as
well as in many Oase components.
The DMX Channel and the mode can be changed by means of a DMX controller from OASE. Read the cor-
responding operating instructions.
Description Value
Serial No. (SN) Enter the unit serial number. The serial number is indicated on the
type plate .
Manufacturer ID 11
Version No. 1
DMX Channel The factory-set DMX Channel is indicated on the type plate.
Configuration 1 Set the DMX Channel for the respective output.
mode ...
4
5 Set the DMX Channel for all outputs (shared control).
10 Operating mode (Personality ID)
20
Underwater LED
Driver / DMX / 02
Version 2.0
DC 24 V / max. 7,5A
IP68
4 m
OASE
GmbH
Tecklenburger Str. 161, 48477 Hörstel, Germany

50720
‚
01234
12
123456789
SN: 123456789
max. 35°C