Hatco TQ-10 Serie Manual De Instalación Y Funcionamiento página 13

MAINTENANCE
GENERAL
The Hatco Toast-Qwik Electric Conveyor Toasters are designed
for maximum durability and performance, with
minimum maintenance.
WARNING
To avoid any injury, turn the power switch OFF, unplug the
unit from the power source and allow to cool before performing
any maintenance.
CLEANING
WARNING
This appliance is not of jet-proof construction. Do not use
jet-clean-spray to clean this appliance.
Exterior
To preserve the bright finish of the unit, it is recommended
that the exterior surfaces be wiped daily with a damp cloth.
Stubborn stains may be removed with a good stainless steel cleaner
or a non-abrasive cleaner. Hard to reach areas should be cleaned
with a small brush and mild soap.
CAUTION
Use only non-abrasive cleaners. Abrasive cleaners could scratch
the finish of your Toast-Qwik toaster marring its appearance
and making it susceptible to soil accumulation.
Toast Crumb Tray & Toast Collector Pan
Remove from unit and wash with soap and water,
then rinse.
Toast Feed Ramp
Press in the two wire spokes and remove guide from unit. Wipe
clean with a soft, damp cloth or soak the guide in a mild solution
of 227 milliliters of ammonia and 3.785 liters of water (1 cup and
1 gallon). Re-install guide by aligning wire spokes
with holes in toaster.
Bottom Heating Reflector
The bottom heating element reflector has slots which allow bread
crumbs to drop through to the crumb tray. Over an extended period
of use bread crumbs may buildup on the reflector and not drop
through onto the tray. To remove buildup, allow the toaster to cool
and wipe the crumbs onto the crumb tray using a bristle brush.
LUBRICATION
The conveyor gear motor and conveyor system
are permanently lubricated and require no lubrication.
Form No. TQ2CEM-0903
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service Department
at 800-558-0607 or 414-671-6350; fax 800-690-2966
or International fax 414-671-3976.
This product has no "user" serviceable parts. To avoid damage
to the unit or injury to personnel, use only Authorized Hatco
Service Agents and Genuine Hatco Parts when service
is required.
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have the
characteristics that will allow them to operate safely in Hatco
equipment. It is essential to use Hatco Replacement Parts when
repairing Hatco equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
11
WARNING
WARNING
WARNING