Tabla de contenido
Publicidad
Repair
Adjusting the Cutter
Operating Link
Figure P
Figura P
25006/00042 Rev I
1. Remove the left cover plate by removing the three screws.
2. Loosen the screw that secures the cutter operating link bushing.
3. Once the screw is loosened, the cutter operating link bushing (eccentric) can be
turned clockwise or counter-clockwise to adjust the height of the moveable cutter as
needed.
4. Tighten the screw securing the operating link bushing.
5. Replace the coverplate
Cover Plate Screw
Vis de la plaque de couverture
Tornillo de la tapa
Cutter Operating Link
Articulation de commande du couteau
Eslabón de operación del cortador
Cutter Arm
Bras du couteau
Brazo del cortador
Cutter
Couteau
Cortador
Screw
Vis
Tornillo
47
Publicidad
Tabla de contenido
