Nelson EZ PRO Serie Guia De Instalacion página 7

INSTALLATION INSTRUCTIONS
For models 8604, 8606, 8608, 8612, 8616, 8620, 8624 (see figure 1)
Remove the transformer cover by loosening the two screws. Attach AC wires to transformer
wires using wire nuts. Also, ensure earth ground wire is attached to green with yellow stripe
ground wire. Please check local codes for the grounding requirements in your area. Bundle
wire within cable tie loop and tighten cable tie to prevent loose wiring from touching secondary
circuits. The transformer is now wired. Replace the transformer cover and the two screws.
DO NOT turn on power yet.
NOTE: Failure to ground unit properly may cause severe damage to the controller
and/or personal property and will void warranty.
Sensor
Port
Figure 1
5