NSK Multi Pad Manual Del Usuario página 15

9–1–6 [6. Endo alert] : Setting the alarm in Endo (Endodontics) mode.
1.Language
2.Gear ratio
3.Lamp
4.Endo mode
5.Air
6.Endo alert
7.Others
8.Version
9–1–7 [7. Others] : Other settings.
At setup mode, select "Others" on the screen. Then you will see the next selection shown below.
Select the LCD contrast that you want to use, "– 2", "– 1", "0", "+ 1", "+ 2". Default is "0".
Select the Backlight timer that you want to use, 1 minute to 30 minutes or infinite. Default is 10 min.
Select the acceleration time that you want to use, 0.5 seconds to 3.0 seconds. Default is 0.5 sec.
When you select "Default setting" by pressing ENTER/SAVE key, you will see the menu of Reconfirmation
screen. Use /
initialized.
Select cable length from 1.2m to 2.6m. Default is 2.2m.
1.Language
2.Gear ratio
3.Lamp
4.Endo mode
5.Air
6.Endo alert
7.Others
8.Version
9–1–8 [8. Version] : Display product information.
1.Language
2.Gear ratio
3.Lamp
4.Endo mode
5.Air
6.Endo alert
7.Others
8.Version
Endo mode alert
Alert setting 1
Alert setting 2
REV alert
key to move to "Yes", then ENTER/SAVE key for 3 seconds. Then the all settings are
LCD contrast
Backlight timer
Acceleration time (NLX)
Default setting
LCD XXXX In case of iMD
NLX XXXX
VA170 XXXX
On / Off
On / Off
–2, –1, 0, +1, +2
In case of iMD
No / Yes
iMD XXXX
14
Cable length (iMD)