Setup - IBM P260 Manual De Instrucciones

Getting Started
Rear
AC IN
(HD15)
1
0 Video input 2 connector (DVI) (J2) (page
4)
Connected to a computer with a DVI video output.
1 2 3 4 5 6 7 8
9 10 12 13 14 15 16 17
17 18 19 20 21 22 23 24
Pin No. Signal
C1 Red
C2 Green
C3 Blue
C4 H. Sync
C5 Ground (R/G/B)
1 –
2 –
3 –
4 –
5 –
6 Data Clock(SCL)*
7 Bi-Directional
Data (SDA)*
8 V. Sync
9 –
* Display Data Channel (DDC) Standard of VESA
4
(DVI)
2
C5
C1 C2
C3 C4
Pin No. Signal
10 –
11 –
12 –
13 –
14 DDC + 5V*
15 Ground
16 Hot Plug Detect
17 –
18 –
19 –
20 –
21 –
22 –
23 –
24 –

Setup

This monitor works with platforms running at horizontal
frequencies between 30 and 121 kHz.
Step 1: Make sure the computer and
monitor are switched off
Step 2: Connect the monitor to the
computer
Connect the video signal cable to the video output of the
computer.
To a computer
forward side
with a DVI
video output
rear side
AC IN
(HD15)
1
forward side
To a computer
rear side
with an HD15
video output
Notes
• Do not short the pins of the video signal cable.
• When connecting the video signal cable, check the alignment of
the connector. Do not force the connector in the wrong way or
the pins might bend.
Step 3: Connect the power cord
With the monitor switched off, connect one end of the
proper power cord for your local supply to the monitor and
the other end to a power outlet.
AC IN
(HD15)
1
to AC IN
Power cord
Step 4: Turn on the monitor and computer
(DVI)
2
(DVI)
2
to a power outlet