SATA jet 1000 ROB RP Instrucciones De Servicio página 107

■ Screw the fluid tip [7-4] in using the
SATA universal spanner.
■ Position the air cap ring [7-6] together
with the air cap [7-5] and screw on by
hand. Heed the correct nozzle setting
and check that the notches in the air
cap are aligned with the tapered dow-
el pin [8-1] (not in the SATAminijet).
■ Insert the paint needle [7-3].
■ Position the spring [7-2].
■ Screw on the end cap [7-1].
■ Screw on the regulation cap (of vari-
ant with material flow control).
■ Adjust the material flow if necessary
(see chapter 9.2).
10.2. Replacing the air distri-
bution ring
Replacing the air distribution ring
must be preceded and followed by
the steps required for replacing the
nozzle set (see chapter 10.1).
Dismantle the air distribution ring
Attention!
The air distribution ring is fitted
firmly in the nozzle head, which
can be damaged if excessive
force is used. Injuries can be
caused if the SATA extraction
tool slips during use.
→ Wear protective gloves.
→ Always use the SATA extrac-
tion tool pointing away from your
body.
→ Pull the air distribution ring
evenly out of the nozzle head.
SATA ROB Automatic Gun Operating Instructions
■ Carry out the steps to dismantle the
nozzle set (see chapter 10.1).
■ Remove the air distribution ring [9-1]
using the SATA extraction tool [9-2].
■ Check sealing surfaces for dam-
age and soiling, clean or replace if
necessary.
Fit new air distribution ring
■ Insert the air distribution ring [10-3]
in the nozzle head [10-2]. The pin on
the bottom of the air distribution ring
must be aligned accordingly [10-1].
■ Press the air distribution ring in
evenly.
■ Carry out the steps to install the new
nozzle set (see chapter 10.1).
10.3. Replacing the paint
If the two paint needle seal re-
tainers are damaged, material
can leak from the gun body in-
spection hole [1-11].
→ Replace the paint needle seal
retainer immediately.
Dismantle the paint needle seal retainer
■ Unscrew the regulating cap (of variant
with material flow control).
■ Unscrew the end cap [11-1].
■ Remove the spring [11-2].
■ Remove paint needle [11-3].
■ Unscrew four cheese-head screws
[11-7] using an Allen key.
■ Remove four spring lock washers [11-
6] from the cheese-head screws.
■ Take the nozzle head [11-5] from the
gun body [11-4].
needle seal retainers
Attention!
EN
107