DeWalt DCT419 Manual De Instrucciones página 6

PLASTER AND LATH
Due to the uneven thickness of plaster, it may be diffi cult to locate
studs. It may be easier to identify the metal nail heads in the studs. If
the plaster is reinforced with wire mesh, the hand-held wall scanner will
not be able to reliably detect embedded materials behind it.
TEXTURED OR ACOUSTICAL WALLS AND CEILINGS
When scanning a wall or ceiling with an uneven surface, place thin
cardboard on the surface and scan over the cardboard.
WOOD FLOORING, WOOD SUB-FLOORING AND DRYWALL
OVER PLYWOOD
Due to the thickness of these materials, it may be diffi cult to detect a
wood stud or joist. It may be easier to detect the metal nails that hold
the materials to the stud or joist.
CARPETING
The hand-held wall scanner cannot detect studs or joists through
carpeting. It may be easier to detect the metal nails that hold the
materials to the stud or joist.
NOTE: Sensing depth and accuracy can vary due to moisture, content
of the materials, wall texture and paint.
Regulatory Notices
• This Class B digital apparatus complies with Canadian ICES-003.
• This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Important Safety Instructions for All
Battery Packs
When ordering replacement battery packs, be sure to include catalog
number and voltage. Consult the chart at the end of this manual for
compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below, then
follow charging procedures outlined.
READ ALL INSTRUCTIONS
• Do not charge or use battery in explosive atmospheres,
such as in the presence of fl ammable liquids, gases or dust.
Inserting or removing the battery from the charger may ignite the
dust or fumes.
• NEVER force battery pack into charger. DO NOT modify
battery pack in any way to fi t into a non-compatible charger
as battery pack may rupture causing serious personal injury.
4