Echo DPB-600 Manual De Instrucciones página 18

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Before you start
1. Battery
2. Battery charge status
button
Fitting and removing the battery
The power blower will operate when the battery is installed, the power indicator LED is lit. Make sure the power blower is
properly positioned to prevent loss of control and possible serious injury.
NOTE
The battery comes partially charged from the factory and needs to be fully charged before first use.
1. Battery
2. Ridge
1. Complete position
2. Uncomplete position
3. LED display
WARNING
3. Battery pack latch
3. Battery pack latch
4. Battery pack
4.
When charging is complete, LED will remain GREEN.
∗ A fully discharged battery pack will charge in about 42 min-
utes. (LBP-560-100)
∗ A fully discharged battery pack will charge in about 88 min-
utes. (LBP-560-200)
∗ A fully discharged battery pack will charge in about 336
minutes. (LBP-560-900)
5.
Verify battery is fully charged by removing battery from
charger, then pressing battery charge status button, and
checking LED display.
One green light indicates that the battery has 0-25%
charge.
Two green lights indicate that the battery has 25-50%
charge.
Three green lights indicate that the battery has 50-75%
charge.
Four green lights indicate that the battery has 75-100%
charge.
6.
Disconnect battery charger from power supply.
Fitting the battery
1.
Release trigger switch and move the cruise control lever
completely forward to the stop position.
2.
Make sure power to unit is turned off.
3.
Align ridges on battery with groove on power blower, and in-
sert battery until battery pack latch gets in the complete po-
sition a clicking sound is heard.
IMPORTANT
Before using the power blower, make sure that battery is set
correctly with battery pack latch in the complete position.
NOTE
Battery pack latch is in the complete position when battery
pack latch is correctly engaged.
16

Publicidad

Tabla de contenido
loading

Tabla de contenido