Maintenance And Care; Troubleshooting Table - Echo DPB-600 Manual De Instrucciones

Maintenance and care

Troubleshooting table

Trouble
Red Charger light flashes or does not light up
Unit will not turn on
Unit does not run when turned on
Running time is too short
Unit runs, but doesn't blow or is weak
Unit vibrates excessively
Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your ECHO dealer. Do not attempt to dismantle the product.
Consult your dealer in the event of a problem that is not covered in the table above, or other such concerns.
For spare parts and consumables, please use only genuine parts and designated products and components. Using parts from
other manufacturers or non-designated components may result in a malfunction.
Cause
Plug not connected to power
outlet
Battery pack not installed prop-
erly
Obstructed connection
Fault in the charger
Fault in the battery pack
Battery pack not installed prop-
erly
Battery pack discharged
Battery pack outside accepta-
ble temperature range
Battery pack outside accepta-
ble temperature range
Unit electronics too hot
Battery pack discharged
Blower pipe clogged
Blower pipe loose
Blower pipe damaged
Air inlet clogged
Fault in the fan
Fault in internal parts
22
Solution
Plug in the charger
Check the battery pack installation
Reinstall battery pack again after
removing obstructions from con-
nection
Consult your ECHO dealer
Consult your ECHO dealer
Check the battery pack installation
Charge the battery pack
Remove the battery pack and al-
low to cool
Remove the battery pack and al-
low to cool
Turn unit off and allow to cool
Charge the battery pack
Unclog pipe
Tighten pipe
Replace pipe
Unclog air inlet
Consult your ECHO dealer
Consult your ECHO dealer