Storage, Transporting, And Mounting; Rip Fence Storage; Miter Gauge Storage - skilsaw SPT99T Instrucciones De Funcionamiento Y Seguridad

SMART GUARD SYSTEM STORAGE
When not in use, the Main Barrier Guard and
Anti-Kickback Device can be stored under the
table .
Use of all the components of the Smart Guard
System, including Main Barrier Guard, Anti-Kick-
back Device, and riving knife is highly recom-
mended to provide protection against accidents
and injury .
1 . Lock the Main Barrier Guard assembly into
place in the same manner as you would
attach it to the riving knife (Fig . 16) .
2 . Attach the Anti-Kickback Device to the
hanging bracket in the same manner that it
attaches to the riving knife (Fig . 16) .

RIP FENCE STORAGE

When not in use, the rip fence can be stored
under the right end of the table on the rails .
1 . Remove the fence from its in-use position on
the rails .
2 . Unlock the rails and extend the rails approxi-
mately 2" to the right of the table. (Fig. 17).
3 . Hang the fence upside down under the rails,
using the right side bolt locations as position
indicators. Ensure that the flip-over fence, in
its stored position .
4 . Latch the front and rear lock levers .
5 . Gently slide the rails back toward the center
until the fence is close to the table saw frame,
and then engage the rail locking lever .

MITER GAUGE STORAGE

When not in use, the miter gauge can be stored
under the back right side of the table .
1 . Insert the front end of the miter guide into the
slot located at the bottom of the push stick
holder (Fig . 18) .
2 . Snap the base end of the miter guide into the
clip located at the rear of the saw .

Storage, Transporting, and Mounting

FIG. 16
FIG. 17
FIG. 18
-22-
Rip Fence
in its Stored
Position