skilsaw SPT99T Instrucciones De Funcionamiento Y Seguridad página 26

ALIGNING RIP FENCE
To prevent personal injury,
WARNING
always
from the power source before making any
adjustments.
The fence is properly aligned to the blade in all
three positions at the factory and should not re-
quire adjustment . This section is intended only
for maintenance purposes or when the fence
becomes unaligned due to impact . The rip fence
must be parallel with the sawblade in order to
prevent KICKBACK when ripping .
Your table saw is equipped with a multiple posi-
tion rack and pinion rip fence . Once the adjust-
ments below have been made, the rip fence will
self align when the fence is locked into one of
the three positions . All three rip fence positions
need to be aligned parallel to the blade . When
moving the rip fence, make sure to unlock and
lock the fence with the rail lock handle and use
the front rail knob to adjust the fence position .
NOTE: The blade must be parallel with the
miter gauge slots (see "Adjusting Blade Parallel
to the Miter Gauge Slots") and be perpendicular
to table before proceeding with rip fence align-
ment .
To prevent personal injury,
WARNING
always make sure that the
rip fence is locked before making rip cuts.
1 . Lift both guard barriers to their up locked po-
sition (Fig. 28) .
2 . Turn the elevation wheel and raise the blade
as high as it will go .
3 . Align the blade to the miter gauge slots per
instructions: ADJUSTING BLADE PARALLEL
TO THE MITER GAUGE SLOTS .
4 . Right side, position 1 (close to blade), see
Fig. 30.
NOTE: The right side position 1 for the fence
permits cuts of 0 to 20 .5 inches on the right side
of the blade . The top scale shows this dimen-
sion. In this location, the flip-over fence should
be on the left of the main fence when in the aux-
iliary fence position (closest to the blade) .
a . Loosen the right side position 1 bolts on the
front and back rails so that they can slide
freely, approximately 1/2 to 1 turn. Move the
bolts to the right by approximately 1/8 inch.
b . Place the fence on the position 1 bolts, but
do not secure the latches on the front or back
rail .
Adjustments
disconnect plug
-26-
FIG. 28
Smart Guard
Blade
c . Move the rails so that the position indicator
lines up with 0 on the top scale . Lock the rails
in place using the rail lock paddle . If an-
ti-kickback pawls are installed, you will need
to raise the right side in order to align the
fence with the blade .
d . Slide the fence with the front and back
screws towards the blade until the fence
touches the blade teeth at the front and back
of the blade .
e . Tighten the front bolt . Verify that the fence is
still in contact with the front and back teeth of
the blade .
f . Tighten the back bolt . Verify that the fence is
still in contact with the front and back teeth of
the blade .
g . Latch the fence clamps onto the rails and en-
sure that the fence is still in contact with the
front and back teeth of the blade .
Rip Fence