Bimar Hi-pet PFC1 Manual De Instrucciones página 10

Fax +32 030 9904733
Attention: fill the dispenser only when the power is off and the adapter is plugged into the power
outlet: always fill the tank only with clean water, drinking water at room temperature; the use of other
substances and / or liquid may be hazardous to the health of the animal.
OPERATION
Warning: before assembling the device, make sure it is disconnected from the power outlet.
Warning: the device may only be used if completely and correctly assembled, which means complete
with tray, lid, filter and bowl. In case of doubt, have it checked or installed by qualified personnel.
The unit consists of the following parts:
- AC / DC adaptor: powers the device electrically.
- Tray: holds the water, electric pump, filter, light and supports the lid. Has
a "window" on the front to see the water level and indicated min and max
levels.
- Electric pump for recirculating water. The pump flow can be adjusted using the lever: pos. +
Maximum flow; pos.- minimum flow; medium in the middle positions.
- Light: inserted in base, shows water level in the tray.
- Filter: inserted in base close to the pump which traps any solids and impurities, reduces bad
tastes and smells.
- Lid: forms the drip tray of the fountain
- Bowl: for food.
Before each use, check that the device is in good condition and, that the wiring is not damaged. If the
power cord is damaged, it must be replaced by the manufacturer or its technical service or a similarly
qualified person, in order to eliminate all risk.
1. Make sure that the device is not connected to the mains.
2. Remove the lid and make sure the filter is correctly positioned in its
place, see the figure; (note: on first use, you must wash it: see section
"Cleaning and Maintenance").
3. Place the lid of the tray so that the cord is positioned on the side opposite
to the tray window, as shown in the figure.
4. Put some water in the tray without exceeding the maximum level
indicated (MAX printed on the tray, max 3.0L).
5. Place the bowl on the lid (maximum 800ml/3 cups).
6. Plug the adapter into the power outlet. The light should come on to
indicate that the unit is in operation. Check the pump flow and adjust it
where necessary using the lever. Periodically check that the level is
always between the maximum and minimum.
7. The device must always be supervised during operation in order to prevent any actions that could
compromise the safety of people and / or animals.
8. Once you have finished using the device, remove the plug from the socket, and empty and rinse
the tray.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
10 28
/
Assembly page 10/28