Connecting The Battery; Automatic Mode; Menu Structure, Automatic Mode - ROBBE POWER PEAK ULTIMATE 2 Manual De Uso

5.2

CONNECTING THE BATTERY

Important !!! Before connecting a battery it is absolutely essential to check once more
that you have set the parameters correctly. If the settings are incorrect, the battery
may be damaged, and could even explode or burst into flames. To avoid short-circuits
between the banana plugs, always connect the charge leads to the charger first, and
only then to the battery. Reverse the sequence when disconnecting the pack.
Take care to maintain correct polarity when connecting the battery: the outputs are cle-
arly labelled. For example, use our transmitter charge lead (No. F1415) and receiver bat-
tery charge lead (No. F1416). If you are not using ready-made charge leads, please
check carefully that the battery is connected correctly.
6.

AUTOMATIC MODE

6.1 Menu structure, automatic mode (NC and NiMH only)
'MODE'
button
'MODE'
button
'MODE'
button
'MODE'
button
'MODE'
button
Operating instructions
POWER PEAK ULTIMATE 2
If you press the 'AUTO' button from the Start
screen, the charger works in automatic mode, in
which case all the parameters are optimised auto-
matically.
'START'
button
'START'
button
'START'
button
'START'
button
'START'
button
9
No.
8470