Setting The Discharge Current; Starting A Charge / Discharge Process - ROBBE POWER PEAK ULTIMATE 2 Manual De Uso

SETTING THE DISCHARGE CURRENT

flashes. You can now select the discharge current in increments of 0.1 A using the '+' or
'-' button. Press the 'ENTER' button again to confirm your selection. The available disch-
arge current range is 0.1 A to 5.0 A, although the maximum current value varies accor-
ding to the cell count and / or the battery voltage. The charger's integral processor limits
the maximum discharge current.
SETTING THE AUDIBLE SIGNAL
can now select the sound which the charger emits, for example, to alert you that the char-
ge process is finished. Five different sounds are available, and the beeper can also be
switched off. Pressing the '+' or '-' button cycles through the available sounds; at the
same time the charger emits the corresponding sound to help you select the correct one.
STORING THE SETTINGS
entered. The screen now reverts to the Start display, i.e. it returns to the starting point.
7.4 STARTING A CHARGE OR DISCHARGE PROCESS
'-' buttons during the process; the new value flashes initially before being adopted.
Operating instructions
POWER PEAK ULTIMATE 2
Press the '+' button to leaf through the screen dis-
play until the arrow indicates Discharge Current.
Press the 'ENTER' button and the '+' / '-' symbol
Press the '+' button to leaf through the screen dis-
play until the arrow indicates Beeper. Press the
'ENTER' button and the '+' / '-' symbol flashes. You
Press the '+' button to leaf through the screen dis-
play until the arrow indicates End, then press the
'ENTER' button to store the settings you have just
•
•
•
•
•
•
Press 'MAN', and the Start display appears.
Press 'ENTER' to prepare the displayed
memory for the charge process.
Select the desired process with the 'MODE'
button.
For security's sake the screen displays the
stored parameters again.
Press the 'START' button to initiate the char
ge process; a beep confirms this. The
screen now changes to a working display,
which shows all the important parameters
(see Chapter 5.1).
You can change the current using the '+' or
15
No.
8470