8Intended use
U se this appliance
I n t e n d e d u s e
Only for refrigerating food.
■
only in the home and in the home environment.
■
only according to these operating instructions.
■
This appliance is intended for use at an elevation of
no more than 2000 meters above sea level.
7Environmental protection
P ackaging
E n v i r o n m e n t a l p r o t e c t i o n
All materials are environmentally safe and
recyclable:
Dispose of packaging in an environmentally
■
responsible manner.
Please ask your dealer or inquire at your local
■
authority about current means of disposal.
Old appliances
Valuable raw materials can be reclaimed by
recycling old appliances.
9
WARNING
CHILDREN MAY BECOME LOCKED IN THE
APPLIANCE AND SUFFOCATE!
Before disposing of your old appliance:
Remove the door.
■
Leave shelves and bins in the appliance to
■
prevent children from climbing in.
Keep children away from the discarded
■
appliance.
9
CAUTION
REFRIGERANT AND HARMFUL GASES MAY
ESCAPE.
Do not damage the tubes of the refrigeration
circuit and insulation.
Pull out the power plug.
1.
Cut through the power cord.
2.
Have the appliance disposed of properly.
3.
5 Installation and
connection
C ontents of package
I n s t a l l a t i o n a n d c o n n e c t i o n
After unpacking all parts, check for any damage
during transport.
If you have any complaints, please contact the
dealer from whom you purchased the appliance or
our customer service.
~ "Customer service" on page 22
The delivery consists of the following parts:
Built-in appliance
■
Equipment (depending on model)
■
Installation material
■
Instruction manual
■
Installation instructions
■
Customer service booklet
■
Warranty enclosure
■
Information on the energy consumption and
■
noises
Technical data
Refrigerant, cubic capacity and further technical
specifications can be found on the rating plate.
~ "Getting to know your appliance" on page 8
Installing the appliance
Installation location
The weight of the appliance may be up to 500 kg
depending on the model. The base must be
sufficiently stable and should not give. If necessary,
reinforce the floor.
Check built-in cut-out
The cut-out must fulfill these criteria:
Anti-tilt bracket must be fitted
■
Cut-out depth min. 24" (610 mm), for flush
■
installation 25" (635 mm)
rectangular
■
stable – the side panels and the top must be min.
■
5/8" (16 mm) thick and securely attached to the
floor or wall
Depth of shortest side panels min. 4" (100 mm)
■
Side-by-side installation
Observe the specifications in the installation
instructions for a side-by-side installation.
If a partition wall is required between the appliances
it must be at least 5/8" (16 mm) wide.
Intended use en-us
5