Glass Information - Muskoka MFBC42WS Manual De Uso Y Cuidado

standard with a 6 ft (1.8 m) long 3 wire cord, exiting out the back of the fireplace insert. Plan the
installation to avoid the use of an extension cord. If an extension cord must be used, it must be a minimum
14 ga, 3 wire with grounding type plug and connector and rated not less than 1875 watts. The extension
cord shall not be more than 20 ft (6 m) in length.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations
to reduce the risk of fire, electrical shock and injury to persons.
Do not use this fireplace insert if any part of it has been under water. Immediately call a
WARNING:
qualified service technician to inspect the firebox and replace any part of the electrical system which has
been under water.
Service Instructions
For Your Safety
Service must be performed by qualified/authorized service personnel only.

Glass Information

Under no circumstances should this product be operated with a broken or chipped glass panel.
1.
Do not strike or slam the glass.
2.
3. Do not use abrasive cleansers to clean the glass.
This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be
4.
done by qualified/authorized service personnel only.
Installing the Ember Beds
You will need one phillips head screwdriver and
remove the 3 ember beds from the carton to
complete the following instructions:
1. Remove the 6 screws on the back left and
right sides of the firebox that hold the glass
front in place.
2. Carefully remove the glass front.
3. Arrange the ember beds (acrylic crystals,
pebbles or log set) along the inset window
ledge at the front of the electric firebox
4. Replace the glass front.
5. Line up the holes on the front with the holes
on the firebox and insert and tighten 6
screws to hold the glass front in place.
1
x6
3
5
3
2
4
x6