Product Description; Product Installation - Fracarro KCPN Instrucciones De Funcionamiento

KCPN is a programmable channel processor for converting an analogue TV channel or a digital multiplex
(DTT) from the 47-86 MHz band to another channel within the 47-86 MHz band. The output level can
be programmed and is constant, thanks to the automatic gain control (AGC). The  SAW IF (intermediate
frequency) filters allow the conversion of adjacent channels. The channel processor can be used as a channel
amplifier, with high selectivity, by programming the same channel at the input and output. The module is
already prepared to be managed remotely for future applications.
DEMIXING OUTPUT
USCITA DEMISCELAZIONE
(verso altri moduli) (to other modules)
1V RED POWER
CAVO ROSSO PER
SUPPLY CABLE
ALIMENTAZIONE 12V
LED AGC ON
LED PWR ON
RJ45 PLUG FOR THE
PRESA RJ45 PER
TPE PROGRAMMER
PROGRAMMATORE TPE
INGRESSO
AUTOMISCELAZIONE
SELF-MIXING INPUT
CLIP HOOK ON DIN BAR
NOTTOLINO PER AGGANCIO SU BARRA DIN
ALLOGGIO PER BARRA DIN
Fig. 1
KCPN converter connectors
The following is contained in the packaging:
• 1 KCPN converter
• 1 RJ45 connector.
After programming the module, we recommend the RJ45 connector is left connected to avoid the build up of
dust or other particles. The unit must be installed by attaching it to the DIN bar by pulling down the clip placed
on the back of the receiver as shown in fig. .
The device status is signalled by bi-color LEDs as shown in the following table.
Summary table of the LEDs status:
LED LED status
Permanently on Normal functioning
OFF
PWR ON
Green
Continuous
flashing
Permanently on AGC activated
AGC ON
green
OFF

2. PRODUCT DESCRIPTION

OUTPUT
USCITA
DIN BAR COMPARTMENT

3. PRODUCT INSTALLATION

4. USER'S INSTRUCTIONS
Meaning
Both LEDs off with power
supplied unit: malfunctio-
ning
Configuration by means of
TPE not saved
AGC not activated (low or
missing input signal)
INGRESSO INPUT
Assembling diagram of a KCPN
If you don't press the "S" key of the TPE within a few
minutes, the previously saved configuration is resto-
red. After restoring, the LED is permanently on again.
10
MONTAGGIO SU BARRA DIN
ASSEMBLING ON DIN BAR
3
2
Fig. 
converter on to a DIN bar
Comment
1
KD100