Maintenance Table; Chain Maintenance Table; Problem Identification - Stiga CS 80 Li Manual De Instrucciones

• Normal wear and tear of consumables,
such as cutting means, safety bolts.
• Normal wear and tear.

13. MAINTENANCE TABLE

MACHINE
Check all fasteners
Safety checks/check controls
Check the chain catcher
General cleaning and inspection
Cleaning the chain
Check the machine and bar lubrication holes
Check the chain drive sprocket
Chain maintenance
Bar maintenance
Topping up the chain oil level
* Interventions which must be carried out by your dealer or an authorised assistance centre

14. CHAIN MAINTENANCE TABLE

Chain pitch
inches
3/8 Mini
0.325
3/8
0.404
The table gives the sharpening data for different types of chains,
but this does not mean you can use chains other than those approved
and listed in the "Correct bar and chain combination table".

15. PROBLEM IDENTIFICATION

PROBLEM
1. When the safety button
is pressed, the green
light does not come on
Task
Limiter tooth level (a)
mm inches
9.32 0.018
8.25 0.026
9.32 0.026
10.26 0.031
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
The purchaser is protected by his or her own
national legislation. The purchaser's rights
under the national laws or his or her own country
are not in any way restricted by this warranty.
Frequency
First time
- Before each use
- Before each use
- Before each use
-
-
- Before each use
-
-
-
- Before each use
a
mm
0.45
0.65
0.65
0.80
EN - 15
An then after
After each use
After each use
Once a month
-
-
File diameter (d)
d
inches
5/32
3/16
13/64
7/32
REMEDY
Make sure that the battery is
inserted correctly (par. 7.2.3)
Paragraph
7.6
6.2
7.5
7.4
7.4.2
8.1
8.2 *
8.3, 14
8.4
7.3
mm
4.0
4.8
5.2
5.6