3M Accuspray 26580 Manual De Instrucciones página 11

6. Position the 3M™ PPS™ collar onto the
3M™ PPS™ mixing cup with liner and turn until
tight. Insert 3M™ PPS™ sealing plug prior to
shaking or sealing.
7. Attach spray gun to fi lled 3M™ PPS™ cup.
Note: Prior to painting, users are expected to be
appropriately grounded (by either shoes or heel straps) and
should wear static-dissipative or static-conductive gloves.
Adjusting the Fluid Flow
The fl uid fl ow can be adjusted by using the fl uid needle
adjustment knob as noted in Fig. 1. The spray gun in the kit
is preset in the closed position (pull trigger to verify; there
should be minimal fl uid needle movement). To allow fl uid
fl ow, gently turn the fl uid needle adjustment knob counter-
clockwise 4.5 full turns. These adjustment procedures
will serve only as a starting point. Fine tuning of these
adjustments will be based on your material and technique.
General Set Up and Spray Gun Use cont.
Adjusting the Fan Pattern Size
The fan size is regulated by the fan adjustment knob
as noted in Fig. 2. The spray gun in the kit is preset in
the closed position (gently turn the fan adjustment knob
clockwise to verify; knob should not move). Next, turn the
knob counter-clockwise 1.5 rotation. The fan adjustment
will allow you to spray from a small round to a full
fan pattern.
Fig. 2
9
Fluid Needle
Adjustment
Knob
Fig. 1
Fan Adjustment
Knob