trekstop i.Beat censo Manual De Uso página 11

Mode: System
Switch to the "s " mode.
ysteM
In this mode, you are provided with information on the memory and the installed firmware version. In addition,
you can change the user language and load the factory settings.
Firmware: Under the menu item "f
firmware version of the i.Beat censo.
Memory: Under the menu item "M
disk space of the i.Beat censo.
Language: Under the menu item " l
Default settings: Under the menu item "d
The saved files are not deleted when you do this.
Notes:
• This MP3 player is optimized for the provided headphones (32 Ohm impedance). Using other earphones with a lower impedance
can damage the MP3 player or earphone, especially MP3 players with 2 earphone jacks.
• In certain circumstances, exposing the device to an electrostatic discharge may interrupt the data transfer between the device and
the computer and impair the functions of the device. If this occurs, the device should be unplugged from the USB port and then
plugged in again.
• Note: This device can produce high volumes. To prevent hearing loss, do not listen to high volumes for long periods. If you notice
ringing in your ears, lower the volume immediately or stop using the MP3 player. Please keep in mind that using earphones or
headphones at loud volumes may result in permanent hearing loss. You become accustomed to higher volumes over time, so that
they may seem normal to you; however, your sense of hearing can still be impaired. The higher you adjust the volume, the faster
your sense of hearing can be damaged.
• Note: Using earphones while driving a motor vehicle is not recommended and is prohibited in some countries. Always drive carefully
and with full concentration. Stop using your MP3 player if you become distracted or interrupted by it when driving a motor vehicle
or during other activities that require your full attention.
• Do not use USB cables longer than 3 meters.
The manufacturer retains the right to continually improve the product. These changes may be made without being directly
described in these operating instructions. For this reason, the information provided in these operating instructions may not
reflect the current technical design.
The manufacturer only guarantees suitability for the product's actual intended purpose. In addition, the manufacturer is not
responsible for damages or loss of data and subsequent consequences.
Copyright © 2007 TrekStor GmbH & Co. KG. All rights reserved. Other cited product or company names may be trademarks or
brand names of the respective owner.
", you are provided with informationen about the installed
irMWAre
", you are provided with informationen about the total and free
eMory
", you can select the menu language of the i.Beat censo.
AngUAge
", you can restore the original settings of the i.Beat censo.
efAUlt set
– 11 –
EN