Cabinet Dimensions - Frigidaire FGEF4085PFA Manual De Instrucciones

40" ELECTRIC RANGE INSTALLATION INSTRUCTIONS

Cabinet Dimensions

Clearances and Dimensions
• Provide adequate clearances between the appliance and adjacent combustible surfaces.
• Location - Check location where the appliance will be installed. Check for proper electrical supply and floor
stability.
• Dimensions shown must be used. Given dimensions provide minimum clearance. Contact surface must be
solid and level.
1" (2.5 cm) min
to wall or vertical
surface above
36" (91.4 cm)
E. MINIMUM CUTOUT WIDTH
40 1/4" (102.2 cm)
NOTES:
1. Do not seal the range to the side cabinets.
2. 30" (76,2 cm) minimum clearance when the cabinet is unprotected.
* * 24" (61 cm) minimum clearance between the cooktop and the bottom of the cabinet when the bottom of
wood or metal cabinet is protected by not less than ¼" (0,64 cm) flame retardant millboard covered with not
less than No. 28 MSG sheet metal, 0,015" (0,4 mm) stainless steel, 0,024" (0,6 mm) aluminum, or 0,020"
(0,5 mm) copper.
3. 0" clearance between range and cabinets or vertical surfaces that are below the cooktop height.
4. 0" clearance between range back and rear wall or cabinet.
40 1/8" Min.
(101.9 cm)
30" Min.**
(76.2 cm Min.)
Grounded
Wall Outlet
Figure 2: Cabinet Dimensions
F. HEIGHT OF COUNTERTOP
35 7/8" (91.1 cm) minimum
5
18" Min.
(45.7 cm Min.)
36" (91.4 cm) standard
13" Max.
(33 cm Max.)
24" Min.
(61 cm Min.)
24½" max.
(62.2 cm Max.)