Hammer Drill Safety Warnings - Maktec MT816 Manual De Instrucciones

ENGLISH
(Original instructions)
1 Switch trigger
2 Lock button
3 Reversing switch lever
4 Action mode change lever
5 Grip base
6 Teeth
SPECIFICATIONS
Capacities
No load speed (min
Blows per minute
Overall length
Safety class
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
Explanation of general view
7 Side grip (auxiliary handle)
8 Protrusion
9 Loosen
10 Tighten
11 Drill chuck
12 Chuck key
Model
Concrete
Wood
Steel
–1
)
Net weight
MT816
10 mm
18 mm
10 mm
0 – 2,800
0 – 30,800
242 mm
1.6 kg

HAMMER DRILL SAFETY WARNINGS

1. Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
ENE039-1
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
ENF002-2
and could give the operator an electric shock.
4. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
5. Hold the tool firmly with both hands.
6. Keep hands away from rotating parts.
7. Do not leave the tool running. Operate the tool
only when hand-held.
GEA010-1
8. Do not touch the bit or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
9. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
13 Sleeve
14 Ring
15 Side grip
16 Depth gauge
17 Hex bolt
MT817/MT818
13 mm
18 mm
13 mm
0 – 2,800
0 – 30,800
255 mm/258 mm
1.8 kg/1.7 kg
/II
GEB003-5
3