General Information; Technical Informations - EXPO Quadro Vino Manual De Instrucciones

1. GENERAL INFORMATION

Please follow instructions to ensure proper functioning of the equipment.
The manufacturer declines all responsibility for any malfunctioning caused by failing to follow given instructions.
All packaging materials used are eco-friendly and recyclable. Please dispose properly of the packaging.
2. DISPOSAL OF END-OF-LIFE EQUIPMENT
In compliance with art.13 of the Legislative Decree 25/7/2005, n.151 "Implementation of Directives 2002/95/CE, 2002/96/CE and
2003/108/CE", regarding reduction of hazardous substance usage in electric and electronic appliances, and waste disposal.
The product must be disposed of separately from other waste at the end of its life cycle.
Unlawful disposal of this product by the owner will entail an administrative fine as per current regulations. This product
complies with E.D. 2002/96/CEE RAEE and 2002/95/CEE RoHS.

3. TECHNICAL INFORMATIONS

To ensure optimal functioning, the equipment should be placed in a well-ventilated area, with low humidity and away from direct
heat sources. Avoid exposure to direct sunlight and keep equipment clean from dust and other sediments.
Any damage or defects caused by failure to follow these norms are not covered by the guarantee and are not in any way the
manufacturer's responsibility. It is also recommended to place devices under NORMAL lighting conditions(de ned as 200 LUX)
E.D. 2006/42/EECE
4. SAFETY
ELECTRIC SYSTEM
Most importantly check that voltage matches the one shown on the product tag located on the back of the product.
A tolerance of +/- 6 % is allowed. It is very important to check the voltage level also during equipment operation, keeping in mind
that voltage lower than the allowed tolerance can cause serious damage to the system. Damage caused by a failure to observe
the information in this
paragraph is not covered in any way by the guarantee.
Insert the plug in a mono phase grounded socket. This socket must be permanently accessible to allow equipment disconnection
at any time. Grounding is not only a safety standard but is also obligatory by law. The manufacturer declines all responsibility
whenever this accident
prevention standard is not respected.
Do not insert more than one plug at once when using extension cord.
Do not spray liquids or ammable gases directly inside or near the cellar when plugged in.
OTHER SAFETY INFORMATION
This device was designed and manufactured in compliance to current standards and all safety measures have been employed.
However, residual risk remains:
• Be aware of protruding corners and edges that may cause harm.
• All moving parts are safeguarded and automatically started and halted. It is however recommended to disconnect power
before performing
maintenance and cleaning.
• If the appliance is not to be use for more than three weeks, remove all bottles and switch it off.
• Before cleaning and maintenance is recommended to disconnected the appliance and wait a few minutes.
(In compliance with E.D. 2006/42/EEC)
Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the
manufacturer.
Do not damage the refrigerant circuit.
Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended
by the manufacturer.
Do not store explosive substances – such as aerosol cans with a flammable propellant – in this appliance.
This appliance is intended for commercial and home use.
ENGLISH