Twin-Star International 26EF023GRG Manual De Instrucciones página 6

2. Remove front glass front from the insert
(Fig. 2).
3. Place fireglass as desired (Fig. 3).
Reinstall the glass front turning the
corner screws in a clockwise direction.
Position your completed mantel close to its final location. Make sure you can access the back of
the mantel as your Electric Fireplace Insert will be installed from the back.
Using a Phillips head screwdriver, remove the screws and the metal mounting brackets attached on
either side of the fireplaces center opening. Next unpack the Electric Fireplace Insert carefully. Position
the insert behind the fireplace with front facing the wood mantel.
With the help of an adult assistant, lift the Insert and gently slide it into the opening in the mantel until the
flange is flush against the inside of the mantel. Make sure insert is centered left and right in the opening.
Be careful when placing insert and adjusting, bottom of insert could scratch the finish of the base/hearth
of your fireplace. Re-attach the mounting brackets with the Phillips head screwdriver, and supplied
screws. DO NOT OVER TIGHTEN.
With the help of an assistant, carefully lift completed
unit and place it with the front facing out in the
final location you have chosen for your fireplace.
Make sure to secure the electrical cord before lifting
or moving completed fireplace. When choosing a
final location, make sure you will have clear access
to a grounded electrical outlet.
Read and follow all instructions in this manual
before operating your new fireplace.
Fig.2
Fig.3
INSERT
MOUNTING
BRACKET
ELECTRIC
FIREPLACE
INSERT
E-5
Fig.4
REAR VIEW OF FIREPLACE