Intended Use; Product Features (See Figure A) - Bosch Universal GardenTidy Manual Original

16 | English
gerous. Extension cable, plug and
socket must be of watertight con-
struction and intended for outdoor
use.
For products not sold in GB:
WARNING: For your safety, it is re-
quired that the plug attached to the
product is connected with the exten-
sion cord. The coupling of the exten-
sion cord must be protected against
splash water, be made of rubber or
coated with rubber. The extension
cord must be used with a cable strain
relief.
Products sold in GB only:
u
Your product is fitted with an BS
u
1363/A approved electric plug with
internal fuse (ASTA approved to BS
1362).
If the plug is not suitable for your
u
socket outlets, it should be cut off
and an appropriate plug fitted in its
place by an authorised customer ser-
vice agent. The replacement plug
should have the same fuse rating as
the original plug.
The severed plug must be disposed
u
of to avoid a possible shock hazard
and should never be inserted into a
mains socket elsewhere.
Products that are only sold in AUS
u
and NZ: Use a residual current
device (RCD) with a nominal residual
current of 30 mA or less.
Symbols
The following symbols are important for reading and under-
standing the original instructions. Please take note of the
F 016 L81 834 | (21.03.2019)
symbols and their meaning. The correct interpretation of the
symbols will help you to use the product in a better and safer
manner.
Symbol Meaning
Blow Mode
Vacuum Mode
Movement direction
Reaction direction
Switching On
Switching Off
Permitted action
Prohibited action
Wear protective gloves
Only operate the product with mounted
vacuum tube.

Intended Use

The prodoct is intended for domestic use, for blowing and
collecting leaves and garden waste such as grass clippings in
the area around the garden and house.
The product is not intended for use as a shredder.
It can be dangerous to operate any product in a manner
other than as specifically intended. Misuse can result in per-
sonal injury.
Product Features (see figure A)
The numbering of the product features refers to the illustra-
tion of the product on the graphics pages.
(1) On/Off switch with controller for airflow speed
(2) Motor unit
(3) Fastening screw for safety cover or vacuum tube
(4) Safety cover (blow mode)
(5) Handle on vacuum tube (vacuum mode)
(6) Screw for handle adjustment
(7) Vacuum tube (vacuum mode)
Bosch Power Tools