Belt Installation - Accessmatic Avanti 4000Z Manual De Usuario

vanti
Installation of belt connect plate B
14. Belt installation of double opening
• Installation of belt connector A(1-6)
1. Remove the screw A and lossen the belt connector A.
2. Cut the belt according to the belt cutting table.
3. Both ends of the belt are put into the fastening part from the center of the
fastening part.
4. Fix the fastening part to the belt connector part.
5. Hang the belt to the belt wheel on the side of the motor, then hang up to
the pulley.
6. Tighten screw B and x the belt connector A to the hanger.
• Installation of belt connector A(7-11)
7. Adjust the belt tension with reference to the adjustment of the belt tension.
8. Makes the two doors really in the dosed position.
9. Remove the screw A and lossen the belt connector.
10. Install belt device to belt. Then x with screw A.
11• Tighten screw B after adjusting the position of the door.
12.Tighten screw B after adjusting the position of the door.
Belt
Belt
Screw B
Opening your life
Belt
Screw A
Screw B
Belt
Screw A
13