Operating Manual; Lifting The Vehicle; Lower The Vehicle - Nussbaum POWER LIFT HL 2.60 SST DG Instrucciones De Servicio

5.Operating manual

When handling the lift, it must absolutely comply with safety regulations. Carefully
read the safety regulations in Section 4 before first operation!

5.1 Lifting the vehicle

•
Drive the vehicle into the middle of the lift lengthwise.
•
Secure the vehicle against rolling. Apply the handbrake, put into gear.
•
Swing in the lifting arms and place the adjustable receiving plate at the vehicle
manufacturer specified points. For safe fixture, use attachment supports as needed.
•
The lifting arm block must be ratcheted in after the fixture point has been reached.
•
Consider the total centre of mass, this must be as close as possible to the middle of the
lift.
Depending on the vehicle type, it may be required to raise the receiving plate so that the
vehicle is horizontal in a raised state.
•
Inspect the hazardous area. No person or object may stand in the working area of the lift,
or on the lift.
•
Switch on controls. Turn the main switch to position "1"
•
Lift the vehicle until the wheels are off the ground. Push operating element.
•
If the wheels are not blocked, interrupt the lifting process and check for proper seating of
the carrier plate. Similarly check whether the lifting arm blocks are ratcheted in.
Otherwise, lower the lift and reposition the vehicle.
Ensure secure vehicle placement on the carrier plate, otherwise there is a danger of
the vehicle dropping.
•
Raise the vehicle to the desired working height.
•
Always observe the complete lifting process.

5.2 Lower the vehicle

•
Inspect the hazardous area. No person or object may stand in the working area of the lift, or
on the lift.
Opera ting Ma nua l a nd Inspection Book
POWER LIFT HL 2.60 SST DG
Figure 1:
Figure 2: Main operating elements
Display
Button "Equalise lift rail"
"Lift" button
Main switch
"Lower" button
- 17 -