Tabla de contenido
Publicidad
64
monty 3300 / 3300AIR
iii-5
iii-6
Pneumatic installation
THE AIR INSTALLATION MUST BE PERFORMED
ONLY BY LICENSED PERSONNEL.
WARNING!
EXCESSIVE AIR PRESSURE CAN SERIOUSLY
INJURE PERSONNEL AND DAMAGE THE MACHINE.
The machine requires an air pressure of 8 to 12 bar
(110-170 psi), as marked on the plate of the machine
and on a sticker attached to the cabinet next to the air
inlet.
Ensure that the line pressure is within the limits required
by the machine.
If the air pressure is lower than the minimum required
of 8 bar (110psi) the clamping power of the turntable
and the bead breaker power may be insufficient for
certain tIres.
If the air pressure exceeds 12 bar (170 psi) it is
mandatory to install a pressure regulator before the air
inlet of the machine.
It is suggested that the air supply be equipped with a
water separator to reduce the amount of water at the
air inlet.
BEFORE CONNECTING THE MACHINE TO THE AIR
SUPPLY BE SURE THAT NOTHING IS LEFT ON
THE TURNTABLE AREA (TOOLS,ETC).
After ensuring all the above proceed as follows:
• Connect the rubber hose provided to the inflation
gauge and to the air bloc as shown in Fig.iii-5.
-
1/4" NPT for ELECTRIC POWERED MACHINE.
-
3/8" NPT for AIR POWERED MACHINE.
• Connect the machine to the air supply (max.
pressure of 12 bar - 170 psi) with a rubber hose
(rated for the pressure) with an inside diameter of 6
mm (1/4") (Fig. iii-5).
• Sul modello GP installare il serbatoio dell'aria e
collegare il tubo d'alimentazione come mostrato in
Fig. iii-6.
• To install any accessory on request follow the
instructions enclosed with it.
• In case of installation of an air-filter and lubricator,
check correct functioning.
Operator's Manual
USA - CANADA
Publicidad
Tabla de contenido
