Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: Read entire owner's manual before you attempt
to assemble or operate your new pressure washer.
REMOVE PRESSURE WASHER
FROM CARTON
•
Remove all accessories and parts bag included with pressure
washer.
•
Slice two corners at the end of carton from top to bottom so
the panel can be folded down flat, then remove all packing
material.
•
Roll pressure washer out of carton.
PREPARING PRESSURE WASHER
FOR USE
If you have any problems with the assembly of your pressure
washer or if parts are missing or damaged, contact the local Briggs
& Stratton service center.
To prepare your pressure washer for operation, you will
need to perform these tasks:
•
Attach the handle to the main unit (if applicable).
•
Install oil dipstick on pump (if applicable).
•
Add oil to the engine.
•
Add fuel to the fuel tank.
•
Connect the high pressure hose to the spray gun and the
pump.
•
Connect the water supply to the pump.
•
Connect nozzle extension to spray gun.
•
Select and install desired nozzle (if applicable).
Attach the Handle to the Unit
Your pressure washer may be equipped with any of the following
handles. Please see the appropriate section for your type of
handle.
To attach a slip-over handle:
•
Place the handle onto the handle supports already connected
to the main unit. Make sure the holes in the handle align with
the holes on the handle supports (Figure 2).
Figure 2 — Attach the Handle to the Base
Align Holes
Handle
Handle
Supports
Pressure Washer
NOTE: It may be necessary to move the handle supports from
side to side.
•
Insert the carriage bolt through the hole on the right side of
the handle (viewing from front of unit) and attach the plastic
knob (Figure 3).Tighten the knob by hand.
Figure 3 — Secure Handle
•
Insert the "L" bolt through the hole on the left side of the
handle (viewing from front of unit) and attach the plastic knob
(Figure 3).Tighten the knob by hand. If not installed, add the
vinyl cap to the "L" bolt.
•
Insert the multi–colored nozzles (if supplied) in the spaces
provided in the handle.
To secure a fold down handle:
•
Raise guide handle, secure in place (Figure 4).
Figure 4 - Secure Handle
Lift the handle to upright
position and slide the
locking caps into place
Install Oil Dipstick on Pump
NOTE: Model 01778 (2400 PSI) is NOT equipped with an oil
dipstick.
CAUTION!
You MUST remove the pumps shipping cap and
install the oil dipstick (if equipped). Failure to do so will void the
warranty and damage the pump.
To install the oil dipstick on Models 01779 (2700 PSI) &
01780 (3500 PSI):
•
Make sure your unit is on a level surface.
•
Remove and discard the shipping cap located on the pump
(Figure 5).
4
Publicidad
