Signal Led - Ibiza sound AMP1000USB-BT Manual De Instrucciones

b) ID3 Display: Display for MP3's information.
c) Five Buttons from left to right function as follows
c1) Stop: Use this button to stop this music.
c2) Play/pause: Each time you press this button, the operation changes from play to Pause or
from pause to play.
C3) |<< PREVIOUS: Use this button to re-start the track or to select the previous track.
C4) >>| NEXT: Use this button to select the next track.
C5) Mode select: Simple press allows you to choose the playback support: SD, USB or Bluetooth
Note: If you choose Bluetooth mode, the player will enable the Bluetooth pairing system. You have to
pair your Bluetooth device with the amplifier. For that, you must to enable your Bluetooth function on
your device. Your device will search for the amplifier and find the Bluetooth system called
"BLUETOOTH". To link your device to the player, you must to enter PIN code 0000. Now, your device
and the player are linked. You must to start playback on your device to listen it on the amplifier.
4. Power Switch
Press down the button to turn on this unit. The LED will illuminate when the power is on.

5. SIGNAL LED

Indicates the signal on input.
6. CLIP LED
Indicates the clipping of the amplifier. when signal input level exceeds the output capacity of the
amplifier channel. If the led flashes, reduce the input level.
Rear connections
1. Line input
Jack sockets: These sockets are connected in parallel to the corresponding RCA connectors. Thus,
you can connect a second amplifier in series to the first unit to send the same signal into several
amplifiers in order to increase the audio power.
2. Speaker outputs
Binding posts or XLR/Jack (minimum load 4 Ohms)
Note : To avoid damage to the speakers, only use speakers that have the same impedance and power
rating as the amplifier. Only use speaker cables and never signal cables as those used for
microphones, music instruments and audio equipment in general.
3. Power supply
Mains
SPECIFICATIONS
Music power ................................................................................ 2 x 800W 4Ω
.................................................................................................... 2 x 600W 8 Ω
Total harmonic distortion ....................................................................... ≥0,5%
Freq. Range 20-20.000Hz .................................................................... ≥0,5dB
Noise ...................................................................................................... ≥98dB
Channel separation (f=1kHz) ................................................................. ≥82dB
Input level ................................................................................................ ≥0dB
Input impedance .................................................................................... ≥10kΩ
Power supply ....................................................................... 230Vac, 50-60Hz
©Copyright LOTRONIC2014 Page 4