Replace The Guide Bar And The Chain; Adjust The Chain Tension - GreenWorks Pro 2004502AZ Manual Del Operador

CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
11.1 REPLACE THE GUIDE BAR AND
THE CHAIN
1. Remove the chain cover nuts with the wrench.
2. Remove the chain cover.
3. Put the chain drive links (21) into the bar groove (20).
4. Put the chain cutters (22) in the direction of the chain
operation.
5. Put the chain in position and make sure that the loop is
behind the guide bar.
6. Hold the chain and bar.
21
20
7. Put the chain loop around the sprocket (16).
8. Make sure the chain tension pin hole (19) on the guide
bar fits correctly with the bolt (17).
English
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the nuts when the chain is correctly tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
11.2
The more you use a chain the longer it becomes. It is
therefore important to adjust the chain regularly to take up the
slack.
Tension the chain so that it can only just be pulled away from
the bar at its centre point.
A slack chain may jump off and cause serious or even fatal
injury.
Wear protective gloves if you touch the chain, bar or areas
around the chain.
1. Stop the machine.
2. Loosen the lock nuts with the wrench.
22
It is not necessary to remove the chain cover to adjust the
chain tension.
3. Turn the chain adjustment screw clockwise to increase
4. Turn the chain adjustment screw counterclockwise to
11
16 17
NOTE

ADJUST THE CHAIN TENSION

WARNING
CAUTION
NOTE
the chain tension.
decrease the chain tension.
EN
19