dirna Bergstrom bycool COMPACT 3.0 Instrucciones De Montaje página 19

COMPACT 3.0
OUTSIDE CABIN:
5
Position Compact in sun hatch hole.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM
seal.
Position the foam rubber, ensuring the softest
6
part is placed on the base of the unit.
Caution: Depending on the cabin, it may be
necessary to use the (2) supplied ducts in
order for the distribution panel to be completely
adjusted.
INSIDE CABIN:
7
Screw about 5 mm (4) 8/125x70,100 or 120
mm studs, the exact measure is chosen after
the fastening supports have been presented
and taking into account that studs must stick
out of lower part about 20 mm.
Following this order:
8
- plane rubber wash
- plane ruber wash wide wing diameter 8
- nut M8
- plane washer diameter 8 wide wing
Sun hatch
6
Unit base
7
7
plane ruber wash
plane rubber
wide wing Ø 8
wash
8
19
5 mm
Stud
Bracket
20 mm
plane washer Ø8
nut M8 wide wing
EN
®
5
7