Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610019162 10-11:BM 2610019162 10-11.qxp 10/20/11 8:59 AM Page 16
To avoid possible injury, disconnect plug from power source before performing any
WARNING
assembly, adjustments or repairs.
Depth adjustment lock knob – used to lock the
cutting head in position.
1. Loosen the depth adjustment lock knob (Fig. 18).
FIG. 18
DEPTH
ADJUSTMENT
LOCK KNOB
2. Hold the depth adjustment handle to raise or
lower the saw blade to the desired position.
3. Turn the depth adjustment lock knob to lock the
cutting head in place.
Depth stop adjustment knob – used to adjust the
lowest position of the blade:
1. Loosen the depth adjustment lock knob fully and
the locking nut (located under the depth stop ad-
justment knob) (Fig. 19).
2. Use the depth adjustment handle to lower the cut-
ting head to its lowest position.
3. Holding the head down with hand, turn the depth-
stop adjustment knob to raise or lower the lowest
position of the blade.
Adjustments
Depth Adjustment
DEPTH
ADJUSTMENT
HANDLE
DEPTH STOP
ADJUSTMENT
KNOB
4. Tighten the locking nut.
5. Tighten the depth stop adjustment knob and
depth adjustment lock knob.
NOTE: To cut all the way through the workpiece,
make sure that the lowest position of the blade is
3/16" (5 mm) below the surface of the work table
(Fig. 20).
FIG. 20
BLADE
SURFACE OF WORKING TABLE
-16-
DEPTH ADJUSTMENT
LOCK KNOB
3/16" (5 mm)
FIG. 19
LOCKING
NUT
BLADE RIM
Publicidad
