Bosch TC10 Instrucciones De Funcionamiento página 24

BM 2610019162 10-11:BM 2610019162 10-11.qxp 10/20/11 8:59 AM Page 24
Periodic maintenance of your tile saw allows for long
life and trouble-free operation. The saw can gener-
ate considerable quantities of cutting residue. A
cleaning, lubrication, and maintenance schedule
should be maintained.
As a common-sense and preventative maintenance
practice, follow these recommended steps:
• Clean the entire saw, except electrical parts, with
fresh water after each use.
• Pump clean, fresh water for 1 minute through the
water pump and blade-guard assembly to safe-
guard against slurry build-up and clogging.
• Inspect the diamond blade for it is overall integrity.
Check the rim for wear or damage.
• Use a soft cloth to clean the water and dust on the
machine.
• Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not at-
tempt to clean by inserting pointed objects through
openings.
Never use water or any other
CAUTION
chemical liquids for cleaning the
electrical parts of the machine.
FRONT PLATE
Front Plate
ACCESSORY
Accessory
Sponge
SPONGE
FIG. 37
IMPELLER Impeller
Impeller PUMP Pump
IMPELLER
Lid SHAFT Shaft
LID
Cleaning the Water pump
1. Remove the front-plate accessory and remove the
sponge.
2. Turn the impeller lid counterclockwise until the
raised rib of the impeller lid disengages from the
groove. Remove the impeller lid and impeller, and
use a small brush or stream of water to clean any
debris.
3. Re-assemble the pump, referring to (Fig. 37).
Note: The pump shaft cannot be removed.
Note: If the volume of water pumped by the water
pump is reduced or none after cleaning the water
pump, replace the water pump or have it repaired
by a qualified service professional.
Changing Carbon Brushes
Replace the carbon brush on both sides of the motor
when the motor stops running, or the carbon brush
is worn out (only approximate 9/32" or 5/16" (7 or
8mm) in length).
1. Bevel the head to 45° and remove the motor
water shield.
2. Loosen the plastic cap with a screwdriver, and pull
out the worn carbon brushes (Fig. 38).
3 . Insert Bosch certified service part new carbon
brushes, replace the plastic caps, water shield
and tighten.
WATER
SHIELD
-24-
FIG. 38
CARBON
BRUSH CAP