Summer PictureMe Manual De Instrucciones página 3

S E T U P & U S E c o n t i n u e d :
ADDING ADDITIONAL CAMERAS
Note: This product can accept two cameras. To order an additional camera (our part number 02921), please contact our Customer
Service Department by phone at 1-800-268-6237 or via e-mail at customerservice@summerinfant.com for details. (For Europe Call
+44 (0)208 420 4429 or customerserviceuk@summerinfant.com)
Plug the AC adapter into AC jack in the bottom of the Camera and the other end into a standard wall outlet.
Slide Switch on side of Camera to ON and POWER ON LED will illuminate solid green.
Menu Selection:
Turn on Camera and and Monitor/parent unit, then slide the switch on the side of the parent unit to MONITOR.
Press the MENU button on the front of the unit.
Press the Right or Left
ADD CAMERA - Press the CODE button at the back of the monitor until the Power LED flashes amber and within 10 seconds,
press the CODE button once at the back of the camera. The image from the new camera should appear on the screen.
Please bring the camera and receiver close to each other during the process, to make sure the signal is strong enough and to
prevent failure caused by interference.
Camera Scanning:
The monitor is designed with a scanning feature that will allow parents to scan between the two cameras with each scan duration of about
14 seconds.
Step 1: Make sure additional cameras are paired with the parent unit and turned on. See "Adding Additional Camera's" section (above).
Step 2: To activate the SCAN feature, call up the OPTION menu by pressing the MENU button on the monitor. Scroll to
and select
Step 3: The monitor will scan all active cameras and image will appear on the screen for about 14 seconds.
Step 4: To exit scanning and to view a particular camera, press the MENU button once and select
Step 5: To resume scanning, repeat Step 2.
Testing Your Initial Setup:
Be sure to test your Monitor's reception before initial use.
We also recommend testing your Monitor's reception periodically. Please keep in mind that the PictureMe™ Colour Video Monitor
will not provide the same level of picture quality as your television with cable, satellite dish, or digital service.
To test reception you will need two adults. One adult should view the picture on the Monitor while the other is in the nursery to
adjust the Camera. Often the quality of the reception can be improved by slightly repositioning the Camera, Monitor, or both. It may
help to place a stuffed animal or doll in the crib to simulate the position and size of your baby. Adjust the picture quality on the
Monitor as needed by using the Brightness Adjustment.
To test sound quality, have one adult speak in both a normal tone and a whisper near the crib. Adjust volume on the Monitor's
Volume Adjustment as needed.
Pairing MONITOR and CAMERA:
The Monitor and Camera are paired at the factory for privacy reasons. If the Monitor and Camera are not pairing with each other
for any reason, please pair them as described below.
Step 1: Move the Monitor to the same area as the Camera. With both the Camera and Monitor on, press the MENU button on the
Monitor to call up the OPTION menu. Select choice of channels
The selected
Step 2: Press the CODE button until the Power LED flashes amber and within 10 seconds, press the CODE button once at the
back of the camera.
Step 3: You should then see a picture from the Camera on the Monitor.
Step 4: If this is unsuccessful, you should repeat steps above making sure the Camera and Monitor are close enough to each other
for pairing.
T I PS F OR IMPROVIN G RECEPTION :
• Position the Monitor closer to the Camera if necessary.
• Move Monitor away from other monitors, cordless phones, walkie-talkies, etc.; moving even slightly could greatly improve reception.
• If you hear a feedback or squealing noise, move the Camera and the Monitor further away from each other.
button to select .
, then confirm selection by pressing the MENU button once.
will be highlighted with a GREEN box.
by scrolling the or
.
button.