Compliance - Welch Allyn ABPM 7100 Instrucciones De Uso

Ocultar thumbs Ver también para ABPM 7100:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 183

31 - Compliance

Compliance
General radio compliance
The wireless features of this monitor must be used in strict accordance with the manufacturer's
instructions as described in the user documentation that comes with the product.
This device complies with Part 15 of the FCC rules and with the rules of the Canadian ICES-003 a
s described below.
Federal Communication Commission (FCC) Interference Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two co
nditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruc
tions, may cause harmful interference to radio communications. However, there is no guarantee th
at interference will not occur in a particular installation. If this equipment does cause harmfu
l interference to radio or television reception, which can be determined by turning the equipmen
t off and on, the user is encouraged to try to correct the interference by one of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance coul
d void the user's authority to operate this equipment.
Industry Canada (IC) emissions
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject t
o the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the d
evice.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exem
pts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne d
oit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
This radio transmitter (IC ID: 5123A-BGTWT11IA) has been approved by Industry Canada to operate
with the antenna listed in the specification table.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conform à la norme NMB-003 du Canada.
European Union
Hereby I.E.M. GmbH declares that this ABPM 7100 is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
Bluetooth
®
Category
Feature
Wireless specification
Bluetooth
Transmit Power
Range
Coexistence
802.11
Antenna
Internal, chip antenna
Environmental
Operating Temperature
Approvals
Bluetooth
FCC / IC / CE / MIC / KC
This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU
member states and EFTA countries, except in France and Italy where restrictive use applies.
In Italy the end-user should apply for a license at the national spectrum authorities in order t
o obtain authorization to use the device for setting up outdoor radio links and/or for supplying
public access to telecommunications and/or network services.
This device may not be used for setting up outdoor radio links in France and in some areas the R
F output power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz.
For detailed information the end-user should contact the national spectrum authority in France.
Norway — Do not operate the ABPM 7100 Bluetooth function in the geographical area within a radi
us of 20 km from the center of Ny-Ålesund.
United Arab Emirates
TRA
REGISTERED No:
ER40002/15
DEALER No:
DA44647/15
Compliance - 32
Implementation
v2.1 / v.2.1 + EDR
Class 1, +12 dBm
100 meters line-of-sight
IEEE 802.11
Max. gain 0.5dBi
-40C to +85C
Registered
Approved

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido